Abstract The high strength Mg-4Zn-0.5 Ca-0.5 RE magnesium alloy was subjected to
different hot deformation processes of extrusion, forging, and their combination for grain …

Grain refinement and enhanced mechanical properties of Mg–2Zn-xCa alloys (with a wide
range of calcium contents from 0 to 5 wt%) were studied in both as-cast and extruded …

The microstructure and mechanical properties of Mg–Zn-0.5 Ca-0.5 RE magnesium alloy,
with zinc contents of 0, 2, 4, and 6 wt%, were studied. A significant effect of Ca and rare earth …

Abstract The Mg-4Zn-0.5 Ca alloy was processed by the combination of forging,
homogenization and extrusion in present study. The results showed that homogenization …

In this study, ultra-fine grain Mg-3Zn-xCa-0.6 Zr (x= 0, 0.6, 1.2, 1.8) alloy was obtained by a
novel extrusion-shearing (ES) deformation process combining initial forward extrusion and …

In this study, the hot-deformation behavior of a die-casted Mg–Al–Zn–Ca–Mn–Zr alloy was
investigated in the temperature range of 548–673 K and the strain rate range of 0.0001–1 s …

The Mg–5.3 wt.% Zn–1.13 wt.% Nd–0.51 wt.% La–0.28 wt.% Pr–0.79 wt.% Zr alloy prepared
by direct chill casting is subjected to hot extrusion. The effects of extrusion ratio and …

Abstract Mg-1.58 Zn-0.52 Gd (wt.%) alloy was subjected to slow-speed extrusion at 350° C
and 400° C combined with hot pre-forging. The extruded alloy without pre-forging exhibited …

The microstructure, texture, residual stress, and tensile properties of Mg–6Zn–2Y–1La–0.5
Zr (wt%) magnesium alloy were investigated before and after extrusion process, which …

The effect of aging treatment before extrusion on microstructure and mechanical properties
of Mg-6Zn-1Mn alloy was investigated. Results showed that the existence of dispersive fine …