The purpose of this study was to identify plastic flow behavior and microstructural evolution
during sub-transus hot deformation of a Ti-6Al-4V alloy with three initial microstructures …

A hybrid of (TiB+ TiC) reinforced Ti-6Al-4V (TC4) matrix composite was produced by solution
ball milling and spark plasma sintering process. The reinforcements were uniformly …

Morphological and compositional evolution of omega (ω) precipitates in a model Titanium-
20 wt% Vanadium (or 19 at.% V) alloy has been systematically investigated by coupling …

Manipulating structure, defects and composition of a material at the atomic scale for
enhancing its physical or mechanical properties is referred to as nanostructuring. Here, by …

Environmental control during transfer between instruments is required for samples sensitive
to air or thermal exposure to prevent morphological or chemical changes prior to analysis …

Abstract TiC x contained Al–Ti–C is a kind of grain refiner for Al alloys. In this work, the
influence of C/Ti stoichiometry, ie the x value in TiC x on grain refinement efficiency was …

The high-pressure torsion method was employed to deform Ti-6Al-4V (TC4) alloy. The
ambient temperature and high pressure were used to restrain the grain growth. Clear …

Dynamic recrystallization and strengthening-toughening effects were investigated in the
processed near-Ti-xSi alloy by hot extrusion. The yielding and ultimate tensile strengths …

A novel low-cost titanium alloy (Ti-22Fe-4Si-4Cr) is reported, which has a very high
compressive strength of 2.5 GPa and ultra high hardness of 710 Hv in as cast condition. The …

The low density and high-temperature mechanical properties of intermetallic Ti 3 Al based
alloys are highly desirable for a wide range of critical applications. In this paper, we …