[HTML][HTML] Room temperature deformation mechanisms of a Fe–Mn–Al–C steel
This study aims to investigate the deformation mechanisms of an austenite-based duplex Fe–
Mn–Al–C steel at room-temperature through uniaxial tensile tests, strain rate sensitivity and …
Mn–Al–C steel at room-temperature through uniaxial tensile tests, strain rate sensitivity and …
The influence of silicon additions on the deformation behavior of austenite-ferrite duplex medium manganese steels
The present study systematically investigated the effect of Si additions from 0 to 3 wt.% on
the deformation mechanisms of a 0.2 C-10Mn-3Al medium Mn steel. Two austenite-ferrite …
the deformation mechanisms of a 0.2 C-10Mn-3Al medium Mn steel. Two austenite-ferrite …
Nanoindentation investigation on the initiation of yield point phenomenon in a medium Mn steel
In general, the medium Mn steel with a dual phase microstructure of austenite and ferrite has
a yield point phenomenon. It is still not clear which phase firstly initiates the plasticity and …
a yield point phenomenon. It is still not clear which phase firstly initiates the plasticity and …
Quantitative investigation of strain partitioning and failure mechanism in ultrafine grained medium Mn steel through high resolution digital image correlation
Ultrafine grained medium Mn steel exhibits simultaneous high strength and ductility,
however, often showing Lüders deformation and discontinuous yielding phenomena. The …
however, often showing Lüders deformation and discontinuous yielding phenomena. The …
Effect of annealing temperature on the microstructure and tensile properties of Fe–10Mn–10Al–0.7 C low-density steel
C Zhao, R Song, L Zhang, F Yang, T Kang - Materials & Design, 2016 - Elsevier
The microstructure evolution and tensile properties of the Fe–10Mn–10Al–0.7 C low-density
steel annealed at the temperature range from 700° C to 1200° C for 1 h were investigated in …
steel annealed at the temperature range from 700° C to 1200° C for 1 h were investigated in …
A novel multi-step intercritical heat treatment induces multi-phase microstructure with ultra-low yield ratio and high ductility in advanced high-strength steel
ZJ Xie, G Han, WH Zhou, XL Wang, CJ Shang… - Scripta Materialia, 2018 - Elsevier
A significant volume fraction of 26% retained austenite was obtained via a two-step
intercritical treatment in a low carbon low alloy steel with ultra-high tensile strength of~ 1200 …
intercritical treatment in a low carbon low alloy steel with ultra-high tensile strength of~ 1200 …
[HTML][HTML] On the fatigue and dwell-fatigue behavior of a low-density steel and the correlated microstructure origin of damage mechanism
The present work deals with revealing the fatigue and dwell-fatigue behavior and correlated
damage mechanisms of Fe–Mn–Al–C lightweight steel. Surprisingly, alteration in loading …
damage mechanisms of Fe–Mn–Al–C lightweight steel. Surprisingly, alteration in loading …
Microstructure evolution and age-hardening behavior of microalloyed austenitic Fe-30Mn-9Al-0.9 C light-weight steels
The aging behavior and mechanical properties of microalloyed austenitic Fe-30Mn-9Al-0.9
C light-weight steels were investigated through transmission electron microscopy analysis …
C light-weight steels were investigated through transmission electron microscopy analysis …
β-Mn formation and aging effect on the fracture behavior of high-Mn low-density steels
The β-Mn formation behavior of high-Mn low-density steels was investigated in terms of the
morphological characteristics and alloying element distribution after aging treatments. A …
morphological characteristics and alloying element distribution after aging treatments. A …
Effects of the strain rate on the tensile properties of a TRIP-aided duplex stainless steel
Factors influencing the strain-rate dependence of the tensile properties of TRIP-aided lean
duplex stainless steel were investigated by employing several characterization techniques …
duplex stainless steel were investigated by employing several characterization techniques …