Effects of peening duration on surface and wear properties of aircraft graded AA2017 alloy
This investigation addresses the effects of peening duration during SP on surface properties
of AA2017 alloy. SP performed with different durations (0, 70, 140 and 210 s) and imparts …
of AA2017 alloy. SP performed with different durations (0, 70, 140 and 210 s) and imparts …
Influence of Cryo-cross Rolling and Post-Rolled Annealing on Microstructure and High Cycle Fatigue Properties of Al-5052 Alloy
The present work investigates the influence of cryo-cross rolling (CCR) followed by
annealing (CCR+ AN) on high cycle fatigue (HCF) of ultrafine grain (UFG) Al 5052 alloy …
annealing (CCR+ AN) on high cycle fatigue (HCF) of ultrafine grain (UFG) Al 5052 alloy …
In-situ monitoring of additive friction stir deposition of AA6061: Effect of rotation speed on the microstructure and mechanical properties
Q Qiao, L Wang, CW Tam, X Gong, X Dong… - Materials Science and …, 2024 - Elsevier
The AA6061 alloy depositions fabricated under three rotation speeds (Ω, 450, 500 and 550
rpm) are obtained by the additive friction stir deposition (AFSD) technique in this study. The …
rpm) are obtained by the additive friction stir deposition (AFSD) technique in this study. The …
A new approach to achieving high strength and ductility of ultrafine grained commercial Al-Mg alloys
TS Orlova, DI Sadykov, DA Kirilenko… - Materials Today …, 2025 - Elsevier
Ultrafine grained (UFG) high strength Al-Mg alloys generally suffer from low ductility. This
paper proposes a new approach involving extremely short annealing at enhanced …
paper proposes a new approach involving extremely short annealing at enhanced …
Effect of Al2O3 Reinforcement on Behavioural Characteristics of Aluminium Metal Matrix Nanocomposites
The creation of new, cutting-edge materials is a need of the modern era. Owing to their light
weight and favorable strength-to-weight ratio, researchers in this field are creating new …
weight and favorable strength-to-weight ratio, researchers in this field are creating new …
Mechanical anisotropy and fracture behaviour of bulk ultra-fine grained AA2099 alloy
In this work, the effect of cryo-deformation and post-deformation annealing process on
tensile, anisotropic and fracture behaviour of AA2099 has been investigated. The …
tensile, anisotropic and fracture behaviour of AA2099 has been investigated. The …
Аномальное изменение механических свойств ультрамелкозернистых сплавов Al–Mg–Zr при низких температурах
ДИ Садыков, МЮ Мурашкин, ДА Кириленко… - Физика твердого …, 2024 - mathnet.ru
Влияние температуры деформации на прочность и пластичность
ультрамелкозернистого (УМЗ) низколегированного сплава Al–Mg–Zr до и после …
ультрамелкозернистого (УМЗ) низколегированного сплава Al–Mg–Zr до и после …
A Comparative Study of Cryorolling and Cryo-Cross Rolling Treatment on Tensile and Fracture Properties of Al 5052 Alloy
In present study, Al 5052 alloy was cross rolled at cryogenic temperature up to a true strain
of 2.3. The impact on microstructure, mechanical, and fracture behaviour is then examined …
of 2.3. The impact on microstructure, mechanical, and fracture behaviour is then examined …