Appropriate hot-dip coating process parameters are very important for enhancing the
cracking resistance and corrosion resistance of Zn–Al–Mg coatings. In this study, five …

In this work, the composition of the zinc–aluminum–magnesium alloy coating was designed
to have a fixed aluminum–magnesium ratio of 1: 1, while the content of aluminum and …

The present study is dedicated to explore the effect of grain refinement on cracking
resistance of hot-dip galvanized Zn–Al–Mg coatings on steel substrate. In this work, we …

In this work, the effect of the hot dip plating process on the microstructure and properties of
zinc–10% aluminum–mischmetal (Zn-10Al-MM) alloy coated for bridge cable wire was …

Abstract Hot-dip Zn-6Al-3Mg (ZAM) coatings have superior corrosion resistance; however,
their cracking resistance is not ideal. In the present study, the cracking resistance of ZAM …

Abstract Fe90–6% Al 2 O 3 coatings with the different Ti mass fractions were prepared on
S355 steel by laser cladding (LC). The effects of Ti mass fraction on the microstructure and …

In contrast with studies such as those on the effect of a single elemental variable on Zn-Al-
Mg coatings, Mg/Al is considered a variable parameter for evaluating the microstructure of …

Hot dipping Zn-Al-Mg coatings were prepared by rapid induction heating combined with gas
protection. The influence of oxide scale on the structure and surface quality of a hot-dip Zn …

This study delves into the formation, transformation, and impact on coating performance of
MgZn2 and Mg2Zn11 phases in low-aluminum Zn-Al-Mg alloy coatings, combining …

The surface quality of hot-dipping Zn-Al-Mg coatings was significantly influenced by the
composition of fluxes. In this study, five different fluxes were chosen and named as F1 (ZnCl …