The effect of using a pulse shaper technique, such as rounding a striker or applying a pulse
shaper on the signals recorded with the split Hopkinson pressure bar (SHPB) technique …

The study presents the results of investigation on two grades of fully austenitic high
manganese steels subjected to dynamic compression with usage of the Split Hopkinson …

This paper presents an analysis of the mechanical behavior of DP500 steel previously
exposed to cyclic loadings with constant stress amplitude. Stress–strain curves were …

The paper presents result of experimental and numerical tests of plastic deformation of
austenitic steel generated by a nanosecond laser pulse. The shock wave generated by the …

A method of tensile testing of materials in dynamic conditions based on a slightly modified
compressive split Hopkinson bar system using a shoulder is described in this paper. The …

The analysis involved subjecting DP 500 steel to pre-fatigue loads, and then tension at high
strain rates using Hopkinson bar. Digital image correlation method was used to investigate …

An accuracy problem of strain measurement at compression split Hopkinson compression
bar experiments with a splitting-beam laser extensometer was considered. The splitting …

Specimen reinforced with glass and basalt fibers were prepared using Standard Portland
cement (CEM I, 52.5 R as prescribed by EN 197-1) and standard sand, in accordance with …

In this paper, the application of the Rusinek–Klepaczko relation to describe the constitutive
behaviour of Ti6Al4V titanium alloy with an HCP crystalline structure was proposed. The …

This paper presents an analysis of the influence of microstructural evolution due to fatigue
loadings on the tensile behavior of a DP 500 dual phase steel. Firstly, the material was …