Measured forces, chip geometry and tool temperatures from machining a mill annealed
Ti6Al4V at cutting speeds mainly from 1 to 100 m/min, but in some cases down to 0.1 m/min …

Turning is one of the most widely used manufacturing processes in the industrial
environment and the need for performance requires numerical simulation to better …

Abstract Finite Element Modelling used to predict machining outcomes needs to be supplied
with the appropriate material thermomechanical properties which are obtained by specific …

In this paper, the non-uniformly distributed and time-varying heat flux at the tool-chip
interface of a turning tool was estimated on-line based on the solution of an inverse heat …

Taking the influence of turning vibration on the turning temperature into consideration, we
set up a synchronous signal acquisition system for turning temperature and turning vibration …

Tool failures in machining processes often cause severe damages of workpieces and lead
to large quantities of loss, making tool condition monitoring an important, urgent issue …

It is well known that the direct measurement of temperature distribution at the tool-chip
interface in a machining process is difficult to accomplish. Thus, this paper provides an on …

Laser cutting of triangle blank from aluminum foam is carried out. Thermal stress field in the
cutting section is predicted using ABAQUS finite element code in line with the experimental …

Present thermal models for analyzing the thermo or thermo-mechanical characteristics of
machine tools either neglect the effect of thermal contact resistance (TCR) between rough …

During the machining of Ti-6Al-4V the changing deformation mechanisms produce a
complex microstructure of segmented chips, which directly influenced tool-wear and process …