Mechanical milling presents an effective solution in producing a homogenous structure for
composites. The present study focused on the production of 0.5 wt% yttria nanoparticle …

Considering commonly employed carbide particles, titanium carbide (TiC) is regarded as an
excellent reinforcement material due to its superior physical and mechanical characteristics …

The effect of milling time on the morphology, microstructure, physical and mechanical
properties of pure Al-5 wt% Al2O3 (Al-5Al2O3) has been investigated. Al-5Al2O3 …

This article aims to manufacture homogenous dual-matrix Al–Mg/Al 2 O 3 nanocomposite
from their raw materials and give insight into the correlation between powder morphology …

Fine-grained copper (Cu) and copper-zirconia (Cu–ZrO 2) nanocomposites were produced
by high-energy ball milling up to 20 h. Scan Electron Microscope (SEM), Transmission …

The effect of the SiC content on the microstructural, mechanical, and magnetic properties of
Cu (1− x) SiC (x) composite powders (x= 0, 2, 10 and 15 wt%) prepared by high energy …

In the present study, friction stir processing was adopted for surface treatment of Al5083 by
incorporation of CNT and Al2O3 nanoparticles. Microstructural, mechanical and tribological …

Near net shaped metal matrix composites were fabricated using high energy cube milling
and hot pressing process. Cube milling was up to six times faster than commercially …

Abstract Al-WC nanocomposites containing 0.1, 0.25, 0.4 and 0.6 v% of WC nanoparticles
prepared by flake powder metallurgy route utilizing either cold pressing and sintering (CP …

AA 6061 nanocomposites of nanocrystallite powders reinforced with nano-alumina particles
were synthesized and investigated in this study. A uniform distribution of nano γ-Al 2 O 3 in …