Effect of injection strategy optimization on PCCI combustion and emissions under engine speed extension in a heavy-duty diesel engine
Y Lu, C Fan, Y Chen, Y Liu, Y Pei - Fuel, 2023 - Elsevier
To mitigate the consequent emissions of greenhouse gases and to conform to increasingly
strict vehicle emission requirements, experiments and numerical simulation were used to …
strict vehicle emission requirements, experiments and numerical simulation were used to …
Parameters optimization of prechamber jet disturbance combustion system—Effect of prechamber volume and fuel injection mass ratios on performance and exhausts …
Y Lu, Y Qian, D Zhang, Y Chen, Y Pei - Fuel, 2024 - Elsevier
Experiment combined with numerical simulation were used to investigate influences of
prechamber volume ratio (PVR) and fuel injection mass ratio (PFR) on performance and …
prechamber volume ratio (PVR) and fuel injection mass ratio (PFR) on performance and …
Measurement of impinging and boiling droplet temperature by two-color/two-dye laser-induced fluorescence technique using continuous-wave laser
JB Heo, D Kwon, E Yeom - International Journal of Heat and Mass Transfer, 2024 - Elsevier
Abstract The 2-color/2-dye laser-induced fluorescence technique is a non-intrusive method
for measuring temperature in millimeter-scale fluids. This study determines optimal …
for measuring temperature in millimeter-scale fluids. This study determines optimal …
An analytical model of the heating and evaporation of bi-component wall film
A novel analytical model for the heating and evaporation of a bi-component fuel wall film is
presented, in which the unsteady one-dimensional characteristics along the film thickness …
presented, in which the unsteady one-dimensional characteristics along the film thickness …
Effect of pre-chamber fuel injection parameters and EGR on the combustion and emissions of a heavy-duty diesel engine
Y Lu, Y Chen, D Zhang, L Zhong, Y Qian… - Energy Sources, Part A …, 2024 - Taylor & Francis
This numerical simulation investigated the impact of pre-chamber fuel injection timing,
injection angle, and exhaust gas recirculation (EGR) on combustion and emissions in a …
injection angle, and exhaust gas recirculation (EGR) on combustion and emissions in a …
Large eddy simulation of liquid-fuel film: sooting-flame interaction in wall bounded turbulent flows
MA Chemak - 2022 - theses.hal.science
The interaction of premixed flame with a liquid fuel film is the main source of soot generation
in Gasoline Direct Injection engines. The objective of this thesis is the detailed modeling with …
in Gasoline Direct Injection engines. The objective of this thesis is the detailed modeling with …
Experimental investigation on bi-component wall film evaporation on a hot wall
Y He, C Fei, Q Zhang - 2024 - researchsquare.com
Spray-wall impingement is a widely observed phenomenon in modern internal combustion
engines. The formation and evaporation of the wall film significantly impacts the fuel-air …
engines. The formation and evaporation of the wall film significantly impacts the fuel-air …
Modélisation d'un écoulement diphasique évaporatif le long d'une paroi chauffée
F Raoult - 2019 - theses.hal.science
La brumisation en amont d'un échangeur à air permet d'intensifier les échanges de chaleur
entre l'air et les parois de l'échangeur. Ces travaux de thèse sont une contribution au …
entre l'air et les parois de l'échangeur. Ces travaux de thèse sont une contribution au …
Heating and Evaporation of Multi-component Droplets
SS Sazhin - Droplets and Sprays: Simple Models of Complex …, 2022 - Springer
Early developments of the models for multi-component droplet heating and evaporation are
reviewed. A model for multi-component droplet heating and evaporation, based on the …
reviewed. A model for multi-component droplet heating and evaporation, based on the …