Validation and Verification of Computational Model for the Numerical Simulation of the Operational Principle of a Submerged Horizontal Plate Device

GÜ Thum, VB Garozi, RP Maciel… - Defect and Diffusion …, 2024 - Trans Tech Publ
This study describes the validation and verification of a two-dimensional numerical wave
channel with a Submerged Horizontal Plate (SHP). The SHP is a fixed, submerged structure …

Investigation of the influence of the electromagnetic field in the vicinity of high voltage overhead line

A Chervenkov, T Chervenkova - Materials Science Forum, 2016 - Trans Tech Publ
The magnetic and electrical field in the vicinity of overhead power line for high voltage-220
kV is investigated. FEM model is created. Simulations of normal and emergency mode of the …

Calibration of Thermal Analysis Models and Thermal Sensors in a Homogeneous Building Enclosure

E Gil, C Lerma, S Llop, Á Mas… - Applied Mechanics and …, 2019 - Trans Tech Publ
A low-cost data acquisition system that records information with K-type temperature probes
and Dallas thermometers has been designed to carry out this research. For this, both the …

Stiffness and Nature Vibration Analyses of Linear Guideway Type

W Li, GC Tsai, WZ Li, TL Horng - Advanced Materials Research, 2011 - Trans Tech Publ
This study investigated the solution of the rigidity and structural vibration for system of linear
guideway type based on ANSYS workbench. By comparing the results derived from the …

The Analysis and Test about the Carrying Capacity of 2m Microwave Antenna for the Wind Load

YM Xie, YZ Li, ML Zhang - Advanced Materials Research, 2011 - Trans Tech Publ
The carrying capacity of 2m-caliber microwave antenna was analyzed by ANSYS software
under the action of the wind load, the antenna's reliability was analyzed and calculated from …

The Practicability of Automobile External Flow Simulation Based on the Two-Equation Models

XS Li, HW Sun, JH Huang - Advanced Materials Research, 2011 - Trans Tech Publ
Based on the studies of the Standard, RNG models and SST model, a vehicle external flow
field is calculated with three different models. Calculation results are compared with that of …