The paper investigates the cavitation erosion (CE) and sliding wear (SW) resistance of cold-
sprayed Al/Al2O3 and Cu/Al2O3 composites and studies them in relation to a set of metallic …

The resistance to cavitation erosion and sliding wear of stainless steel grade AISI 304 can
be improved by using physical vapor deposited (PVD) coatings. The aim of this study was to …

This study discusses a quantitative fatigue evaluation of polymer–ceramic composites for
dental restorations, ie, commercial material (Filtek Z550) and experimental materials Ex …

The investigation into wear resistance is an up-to-date problem from the point of view of both
scientific and engineering practice. In this study, HVOF coatings such as MCrAlY …

Face centered cubic (FCC) high-entropy alloys (HEA) exhibit excellent ductility while body
centered cubic (BCC) HEAs are characterized by high strength. Development of fine two …

The paper is a report of the examination of the tribological wear characteristics of certain
dental metal biomaterials. In the study, tests were undertaken on the following materials …

The study compares the microstructure of three commercial dental cobalt matrix alloys with
related chemical composition declared by the manufacturer. Casts were produced with lost …

The recasting of dental metal alloys can change the chemical composition of fabricated
casts, which ultimately affects the properties of a dental component. The purpose of this …

Nickel alloys are commonly used in dentistry as base for crowns made with metal faced
ceramics and represent a good alternative to expensive precious alloys [1, 2]. In addition to …

Use of metal base dental prostheses is accompanied by not only wear due to biomechanical
loads that occur during the process of chewing, but also by corrosive wear occurring in …