The intermetallic phases in AA7075-T6, including the nm-scale precipitate MgZnCu and 10-
μm size Mg 2 Si, S-phase, Al 7 Fe 2 Cu (Mn), and Al 15 (FeMn) 3 (SiCu) 2, were identified …

The high-temperature flow behavior of 6A02 aluminum alloy was studied through hot
compressive experiments. Based on the experimental data, the values of strain rate …

Separation of Fe-containing intermetallics is an effective method to decrease Fe content in
Al-Si alloys. Regular morphology and higher precipitation temperature are necessary for …

Purpose: In the technical 6xxx Al alloys besides the intentional additions Mg i Si, transition
metals and impurities (Fe and Mn) are always present. Even not large amount of these …

Aluminum–Magnesium (Al 5083) alloy was subjected to cryorolling (CR) and cryorolling
followed by warm rolling (WR) in order to investigate the changes in mechanical behavior …

This study focuses on primary impurities, called intermetallics, in the microstructure of Al-Si-
X alloys, their formation, effects and treatments to eliminate or ameliorate their deleterious …

The purpose of the present work is to understand the evolution of microstructure and
microchemistry during homogenization of the Al–Mg–Mn alloy AA 5454 (Al Mg3 Mn). It has …

Analysis of the influence of chemical composition, crystallization process and heat treatment
on the phase constituents' morphology, and mechanical properties and crack resistance of …

This encyclopedia, written by authoritative experts under the guidance of an international
panel of key researchers from academia, national laboratories, and industry, is a …

Microstructural development during solidification and subsequent aging, and the resulting
creep resistance, of laser powder-bed fusion (LPBF) Al-3.6 Mn-2.0 Fe-1.8 Si-0.9 Zr (wt%) …