Aluminum alloys can be used in the fabrication of intricate geometry and curved parts for a
wide range of uses in aerospace and automotive sectors, where high stiffness and low …

The processing regime relevant to superplasticity in the Ti–6Al–4V alloy is identified. The
effect is found to be potent in the range 850–900° C at strain rates between 0.001/s and …

Polylactic acid (PLA) and graphene reinforced polylactic acid (PLA‐graphene) composites
have been fabricated by three‐dimensional (3D) fused deposition modeling (FDM) printing …

Multi-phase structure alloys have been widely used in superplasticity deformation due to
their ability to inhibit grain growth. However, the current study on multi-phase structure alloys …

Titanium matrix composites (TMCs) have shown great potential for weight reduction in
aerospace applications. However, hard ceramic reinforcements make the superplastic …

High temperature tensile, electron backscatter diffraction (EBSD) techniques and
transmission electron microscope (TEM) were combined to perform a systematic …

The strain rate sensitivity evolution of a wrought AZ31 magnesium alloy was studied using
strain rate jump (SRJ) testing technique. The strain rate jump tests were conducted in a wide …

Tube forming technologies based on internal forming pressures, such as hydroforming or
hot tube gas forming, are state of the art to manufacture complex closed profile geometries …

The high temperature deformation behavior of 2205 duplex stainless steel under different
conditions had been studied by tensile tests. The whole tensile test was conducted at a …

Isothermal compression tests are conducted using a thermomechanical simulator at a
constant strain rate during deformation temperature range of 850 to 950° C and strain rate …