The drawback of steel fluid flow phenomena for a continuous casting mold under an
electromagnetic stirrer with a traveling magnetic field is the resulting severe meniscus …

The solidification structure and segregation of continuously cast billets produced by different
continuous casting processes are investigated to elucidate their effect on segregated bands …

综述了连铸过程中铸坯表面振痕形成机理的研究状况, 论述了振痕形成机理的主要模型,
讨论了振痕间距和振痕深度互相的影响关系, 分析了振痕深度和振痕间距各自的影响因素 …

Electromagnetic stirrer generates swirling fluid flow, boosts the mixing of molten steel near
the solidification front and enhances the quality of the continuously cast products. In the …

Macro-inclusions in low carbon, aluminium-killed steel slabs were characterised by step-
machining within a 10 mm zone from the slab surface using an ASPEX automatic inclusion …

In the current study, the three-dimensional fluid flow, heat transfer, and solidification in steel
centrifugal continuous casting strands were simulated. The volume of fluid model was used …

通过静态热模拟实验, 采用低熔点Sn-32% Pb-52% Bi (质量分数) 合金作为钢液的模拟介质,
研究不同工艺参数下矩形电磁软接触连铸结晶器内弯月面行为的变化规律. 结果表明 …

The thermal and numerical simulation of the mould electromagnetic stirring (M-EMS) during
continuous casting (CC) of the GCr15 bearing steel was performed. The thermal simulation …

The distribution of surface macro-inclusions is an important parameter that can directly
influence the surface quality of IF steel sheets. In the present work, macro-inclusions> 100 μ …

The effect of electric potential on the solidification behaviour of mould powder has been
studied. It has been found that electric potential induces crystallisation and that the depth of …