Fracture behavior via a flexural test for a newly found CaO–Al2O3–SiO2 (CAS) glass-
ceramic (GC) was compared with that of enstatite GC and mica GC, which are well-known …

The advent of high-flux, high-brilliance synchrotron radiation (SR) has prompted the
development of high-resolution X-ray imaging techniques such as full-field microscopy …

The characterization of subsurface cracks induced by indentation is a challenge for
understanding contact damage, impact, wear, erosion, and abrasion of brittle materials …

Synchrotron X-ray nano computed tomography was used to investigate the microstructural
evolution during co-sintering of multi-layer ceramic capacitors (MLCC) consisting of Ni …

We report an in-situ investigation of a high-temperature ceramic powder sintering performed
for the first time at the particle length-scale. This was made possible by the phase-contrast X …

The conventional fabrication of bulk van der Waals (vdW) materials requires a temperature
above 1,000° C to sinter from the corresponding particulates. Here we report the near-room …

Mechanical properties and thermal deformation capabilities of powder metallurgy (P/M) Ti
alloys are extremely susceptible to pores in the sintered parts. However, deciphering the …

The uniaxial die compaction and sintering is an important industrial production method for
metal and ceramic components. While submicron-and nano-sized powders are finding …

We propose a new method, ie, the statistical phase fraction (SPF) method, to estimate the
total porosity and spatial distribution of local porosities from subresolution pore-dominated X …

The mechanical reliability of products must be assured for scaling up and production of
complex‐shaped components by spark plasma sintering (SPS) of spray‐dried granules. The …