Проблема построения конститутивных моделей, позволяющих описывать поведение
материалов в широких диапазонах изменения параметров воздействия (температур …

Quasi-static tensile and stress-controlled high cycle fatigue tests of solution heat-treated
(SHT) Hastelloy X manufactured by electron beam powder bed fusion (PBF-EB) and laser …

Long-chain aliphatic polyester-18, 18 (PE-18, 18) exhibits high density polyethylene-like
material properties and, as opposed to high density polyethylene (HDPE), can be recycled …

Abstract An Al-Cu alloy fabricated by selective laser melting (SLM) was chosen in this study
for the investigation of Portevin-Le Chatelier (PLC) effects. The effects of the process …

In the present work, a new modeling framework for analyzing flow behavior of Al-Mg alloys is
proposed by considering both direct and indirect effect of solutes on flow stress. While direct …

Plastic flow instability caused by the Portevin Le-Chatelier (PLC) effect and its influence on
the necking instability were studied in a binary and a precipitation-strengthened AlMg alloy …

Using digital image correlation technique, various stages of development of localized
deformation bands caused by the Portevin-Le Chatelier (PLC) instability of plastic flow are …

This article reports an unexpected finding of the mechanical behavior of Al-12% Si alloy
manufactured using the laser powder bed fusion (L-PBF) process. The as-manufactured …

The processing of conventional alloys by laser-based additive manufacturing can be
challenging, particularly for alloys prone to hot cracking. However, additive manufacturing …

Room temperature processing methods of reaching near-T6 yield and ultimate tensile
strength in Al–Zn–Mg–Cu alloys provide a potentially lower cost alternative to high …