Cryomilling, the mechanical attrition of powders within a cryogenic medium, is a method of
strengthening materials through grain size refinement and the dispersion of fine, nanometer …

During the laser-powder bed fusion (L-PBF) process, high laser intensities, short interaction
times and highly localized heat input drive large thermal gradients that result in a state of …

In this work, non-associative finite strain anisotropic elastoplasticity fully coupled with ductile
damage is considered using a thermodynamically consistent framework. First, the …

A new development in the determination of residual stresses in thin surface layers and
coatings is presented. The procedure, based on the grazing-incidence X-ray diffraction …

Using X-ray grazing incidence diffraction (GID) it is possible to perform a nondestructive
analysis of the heterogeneous stress field for different volumes below the surface of the …

The results of crystallographic textures and residual stress measurement in cross-rolled low
carbon ferrite steel and polycrystalline copper of commercial purity are presented. It was …

Voronoi tessellations are shown to be statistically representative of polycrystalline
microstructures, which have been widely accepted for the modeling of microstructures of …

The mechanical properties of both phases in duplex stainless steel have been studied in situ
using neutron diffraction during mechanical loading. Important differences in the evolution of …

A new method for determining the parameters characterising elastoplastic deformation of
two-phase material is proposed. The method is based on the results of neutron diffraction …

In this work the recovery and recrystallization processes occurring in ferritic and austenitic
steels were studied. To determine the evolution of residual stresses during material …