Enhancing dropwise condensation through bioinspired wettability patterning

A Ghosh, S Beaini, BJ Zhang, R Ganguly… - Langmuir, 2014 - ACS Publications
Dropwise condensation (DWC) heat transfer depends strongly on the maximum diameter (D
max) of condensate droplets departing from the condenser surface. This study presents a …

Water retention and drainage on air side of heat exchangers—A review

Z Qi - Renewable and Sustainable Energy Reviews, 2013 - Elsevier
This paper presents the recent advances in water retention and drainage performance on air
side of heat exchangers under wet and dehumidifying conditions. The experimental and …

Synergistic effect of helically-finned directional tracks and lubricant viscosity on droplet dynamics and condensation heat transfer of bioinspired slippery surfaces

F Lv, S Lin, J Miao, C Wang, Z Dong… - International Journal of …, 2023 - Elsevier
Slippery lubricant-infused porous surfaces (SLIPSs) have been presented herein,
developed on helically-fined grooves of copper tubes (HF-SLIPSs). The high viscosity …

Investigation of defrosting water retention on the surface of evaporator impacting the performance of air source heat pump during periodic frosting–defrosting cycles

LT Li, W Wang, YY Sun, YC Feng, WP Lu, JH Zhu… - Applied energy, 2014 - Elsevier
To investigate the impact of defrosting-water retention on the surface of heat exchangers of
the air source heat pump (ASHP) performance during frosting–defrosting cycles, an …

Modeling of heat transfer through a liquid droplet

V Baghel, BS Sikarwar, K Muralidhar - Heat and Mass Transfer, 2019 - Springer
In dropwise condensation, the released latent heat passes through the static and sliding
droplets to the condensing surface at a rate limited by various thermal resistances. In the …

Air-side surface wettability effects on the performance of slit-fin-and-tube heat exchangers operating under wet-surface conditions

L Liu, AM Jacobi - 2009 - asmedigitalcollection.asme.org
A study of condensate retention and the attendant thermal-hydraulic effect associated with
changes in air-side surface wettability is presented for a series of slit-fin-and-tube heat …

Superhydrophobic fins with inclined arrangement for enhancing energy saving of air-cooled wet heat exchangers

M Muneeshwaran, CC Wang - International Journal of Heat and Mass …, 2021 - Elsevier
The energy consumption of the air-cooled heat exchangers such as evaporators operating
under wet conditions is much higher owing to the condensate retention and bridging. The …

Experimental investigation on water drainage characteristics of open-cell metal foams with different wettabilities

H Hu, Z Lai, G Ding, D Zhuang, X Weng - international journal of …, 2017 - Elsevier
For optimizing the metal foam heat exchangers used in dehumidification apparatus, the
influence of surface wettability on drainage characteristics should be explicit. In the present …

Heat transfer and pressure drop characteristics of wet air flow in metal foam with hydrophobic coating under dehumidifying conditions

H Hu, Z Lai, G Ding - Applied Thermal Engineering, 2018 - Elsevier
The heat transfer and pressure drop characteristics of wet air flow in the metal foam with
hydrophobic coating was investigated experimentally, and were compared with those in …

Experimental investigations on the performance enhancement using minichannel evaporator with integrated receiver-dryer condenser in an automotive air …

R Prabakaran, DM Lal, A Prabhakaran… - Heat Transfer …, 2019 - Taylor & Francis
The performance comparison of two automotive air conditioning systems was experimentally
studied under two typical cabin conditions viz; 27° C dry bulb temperature/40% relative …