The effect of long-period stacking ordered (LPSO) phase on hot tearing susceptibility of Mg–
1Zn–xY serial alloys were investigated experimentally using a home-made T-type hot …

In our previous work, die cast LA42 (Mg–4La–2.5 Al–0.3 Mn, wt.%) alloy with an excellent
combination of thermal-conducting performance and mechanical properties was developed …

This paper describes the grain refinement due to equal-channel angular pressing (ECAP)
and the creep properties of the ECAP-processed AZ91 magnesium alloy. The resulting …

为了探索放电性能更好的镁空气电池阳极, 制备了3 种镁合金, 分别为Mg-6% Al-1% Zn, Mg-6%
Al-5% Pb-1% Zn 和Mg-6% Al-5% Pb-1% Zn-0. 5% Sb, 与工业空气阴极, NaCl …

The effect of Yttrium (Y) addition on hot tearing susceptibility of Mg–6Zn–1Cu–x Y–0.6 Zr (x=
0, 1, 2, 3) alloys was investigated using a constrained rod casting apparatus which …

The effects of copper (Cu) content and mold temperature on the hot tearing susceptibility
(HTS) of Mg-7Zn-x Cu-0.6 Zr (x= 0, 1, 2) alloys were investigated experimentally using a T …

Abstract Mg–Zn–Ca alloy has a good development prospect in biomedical alloy. However,
its development is restricted by large hot tearing susceptibility. Herein, the influence of Ca …

The mechanical properties of AZ31 magnesium alloy sheets processed by different
extrusion strain paths were examined in correlation with concurrent microstructure and …

Abstract AM50− 4%(Zn, Y) alloy with a Zn/Y mole ratio of 6: 1 was subjected to thermal
analysis, and the results were used for designing a two-step progressive solution treatment …

The microstructure evolution and growth orientation of directionally solidified Mg–4 wt% Zn
alloy in the growth rate range from 20 to 200 μm/s were investigated. A typical cellular …