Abstract Effects of heating temperature, heating rate, and holding time on the austenitization
process of near-eutectoid high-carbon steel have been investigated. The dilatometric tests …

Plastic anisotropy in the yield stress of pearlitic steels evolved by drawing was studied. The
tension and compression tests were performed in parallel and perpendicular directions to …

The mechanical properties of contemporary engineering alloys are approaching their
natural limits. On the other hand, human civilisation faces further growing challenges …

The simple shear test shows significant advantages when measuring the hardening and
shear properties of thin sheet metal at large strains. However, previous shear tests had an …

In this study, the effects of open-die cold forging on corrosion behavior of pressure vessel
sheet (A516 GR70) were investigated. To reduce the effect of the spring back a die with high …

Although the Bauschinger effect has been investigated in some detail in various materials,
the number of articles on the effect of grain size is extremely limited, and in current …

A bolt with an excellent combination of high strength (1711 MPa) and high elongation
(20.4%) was successfully manufactured using the hot-rolled twinning-induced plasticity …

The present study aims at investigating the low cycle fatigue behavior of two fully AISI 1080
pearlitic steels which differed in their interlamellar spacing (72±15 and 143±32 nm). Low …

The cold roller die process increases the tensile strength and decreases the ductility of steel
wire. Annealing heat treatment is applied to restore mechanical properties, but this is a …

The effect of reverse straining on the microstructure, texture, and hardness of the pure Al
during the single cycle of the simple shear extrusion (SSE) process is investigated. Electron …