An atmospheric‐pressure spatial atomic layer deposition system is used to rapidly deposit
60 nm zinc–aluminum oxide (Zn–AlOx) thin‐film‐encapsulation layers directly on perovskite …

In this paper, the as-cast microstructure, microsegregation, precipitates and suitable
homogenization process of a novel Ni-based wrought superalloy prepared by vacuum …

In this paper, the as-cast microstructure, microsegregation, and the kinetics of (γ+ γ′)
eutectic phase and Laves phase dissolution in GH4151 alloy were studied by the optical …

In laser-based directed energy deposition (L-DED) of Inconel 718 the microstructure of the
fabricated components strongly depends on the applied process parameters and the …

The IN718 superalloy was prepared by hot pressing sintering method, and the IN718 alloy
blocks under different sintering pressures were obtained. The hot-pressed IN718 superalloy …

The chemical composition of standard Inconel 740 superalloy was modified by changes in
the Al/Ti ratio (0.7, 1.5, 3.4) and addition of Ta (2.0, 3.0, 4.0%). Remelted Inconel 740 (A0) …

The investigation of IN718 alloy for aerospace and oil and gas industries focuses on cost-
effective component design, specifically for turbines. Manufacturers for IN718 can achieve …

To investigate the microstructural evolution of wrought-nickel-based superalloy GH4169
from the original ingot to the finished product of manufacturing processes, different kinds of …

This study aimed to investigate the influence of process parameters on crack formation in
laser alloying or cladding of grey cast iron. For this purpose, the effects of laser power and …

The investigation of IN718 alloy for aerospace and oil and gas industries aims to develop
cost-effective components. One approach is using higher Si content scrap, but …