We report a robust two-step method for developing adherent and anticorrosive molybdenum
(Mo)-based coatings over an aluminum (Al) 6061 alloy substrate using a femtosecond (fs) …

A two-step femtosecond-pulsed laser deposition (fs-PLD) process is reported for the rapid
development of uniform, poreless, crack-free, and well-adhering amorphous coatings of …

Hierarchical structures were fabricated on brass surfaces by means of a straightforward 2-
step laser-scribing process. We tested the ability of these surface structures to withstand …

Major research efforts are being carried out for the technological advancement to an
energetically sustainable society. However, for the full commercial integration of …

We report a method to neutralize the mid-gap defect states in MoS2 monolayers using laser
soaking of an organic/transition metal oxide (TMO) blend thin film. The treated MoS2 …

In this work, a novel system for the hot wall evaporation of MoO 3 in a horizontal furnace and
at low vacuum atmosphere was settled. Pure MoO 3 material was obtained without the …

A simple solution combustion technique was employed to synthesize nanocrystalline MoO3,
and the influence of the fuel‐to‐oxidizer ratio (F/O ratio, from 1: 2 to 1: 5) and pH (from 5 to 9) …

In this study, the advanced chemical vapor transport (CVT) method in combination with the
quenching effect is introduced for creating molybdenum oxide nanoparticle arrays …

In recent years, surface-enhanced Raman scattering (SERS) based on metal oxide
semiconductors has been an active area of research and development, attracting significant …

The stability of molybdenum (Mo) back contact and Cu (InxGa (1‐x) Se2 (CIGS) absorber
layers interfaces relevant for CIGS‐based solar cells was investigated using accelerated …