Abstract The International Organisation for Standardisation ISO 6336: 2006 and the
American Gear Manufacturers Association AGMA 2101-D04 are the two most predominant …

Polymer gears are used extensively in various applications. However, durability issues have
been emerging because of friction at gear tooth contact areas. To extend the lifetime of …

A numerical scheme is presented to simulate the meshing process of spur gears, based on
the material point method (MPM). To allow engagements at successive contact points and …

In this study, the impact of misalignments on root stresses of hypoid gear sets is investigated
experimentally and theoretically. An experimental set-up designed to allow operation of a …

In this study, the results of an experimental parametric study of the combined influence of
shaft misalignments and gear lead modifications on the load distribution and tooth bending …

Accurate estimation of tooth-root stress has been of great interest to researchers and
engineers to prevent catastrophic damage of gear transmission system. However, analytical …

This paper presents approaches to element constructions and dynamic analyses for involute
spur/helical gears, including cylindrical and conical categories. High quality elements for …

Based on a few specific cases, this paper presents a comparative investigation of the effect
of helix slope and form deviation tolerances as specified by grades 5 and 7 of the …

The Association of German Engineers VDI 2737: 2005 and the International Organisation for
Standardisation ISO 6336: 2006 are universally accepted analytical procedures for the …

In this work, a profile modification technique was used in design of a spur gear. In this
technique, the tooth-sum is varied to obtain the desired contact ratio and low contact stress …