A combined Brayton/Brayton power cycle has been investigated using the advanced exergy
analysis. The combustion chamber was shown to be the component with the largest exergy …

This study presents comparative energy and exergy analysis of an integrated air-cycle
refrigeration and power generation system with four embodiments as developed in the …

The article is devoted to the reduction of heat losses in air-cooled units with fuel gas heating
using water collectors with finned tubes to increase the thermal conductivity of the collector …

Increasing the inlet air temperature causes a reduction in the air mass flow rate, and the
efficiency and output power of a gas power plant will reduced. To compensate this power …

Gas turbine (GT) power plants operating in arid climates suffer a decrease in output power
during the hot summer months because of the high specific volume of air drawn by the …

This paper reports the comprehensive thermodynamic modeling of a modified combustion
gas turbine plant where Brayton refrigeration cycle was employed for inlet air cooling along …

Gas turbines can be started and stopped easily which make them every useful at peak
period in energy demand. Gas turbines are widely used for electricity generation in Nigeria …

Gas turbine (GT) power plants operating in arid climates suffer from a decrease in power
output during the hot summer months. Cooling the intake air enables the operators to …

Gas turbine (GT) power plants operating in arid climates suffer a decrease in output power
during the hot summer months because of insufficient cooling. Cooling the air intake to the …

Radial Distribution Systems (RDS) require special load flow methods to solve power flow
equations owing to their high R/X ratio. Increasing use of power electronic devices and effect …