Polytetrafluoroethylene (PTFE) is widely used in tribological applications. However, it faces
challenges due to its high wear rate. Reinforcement of additives in PTFE reduces its wear …

Operating conditions were analyzed, thermophysical characteristics were calculated as
applied to VVER-1000 fuel rods in four-year cycle for unified core. Models for calculating gas …

Phenomena occurring in the contact area between two mating bodies are characterised by
high complexity and variability. Comparisons are usually made between parameters such as …

The main aim of presented article is present methodology how sophisticated products as
compressor equipment can be considered and analyzed as a complex technical system …

In the modern conditions of the construction industry, one of the main tasks is to create new
effective materials, improve their quality and thermophysical characteristics, and expand the …

Numerical simulation method of the working process of a centrifugal unit contactless face
impulse seal is proposed. A seal functioning physical model was created. Its operation key …

The article deals with the assessment of production process capability in the serial
production of plastic components. The plastic component was used for analysis. Component …

Moisture sorption and diffusion exacerbate hygrothermal aging and can significantly alter
the chemical and mechanical properties of polymeric-based components over time. In this …

There are considered the features of the structural and phase state of the aluminized
coatings obtained by the method of electric spark alloying (ESA) on the specimens made of …

ZnO, ZnO/Alginate coatings were obtained on the pre-anodized Ti6Al4V substrates by the
thermal substrate deposition method (TSD). In the frame of this work, the TSD method was at …