Silicide-free boride layers were grown on Inconel 718 Ni-based superalloy surface at 850°
C, 950° C, and 1050° C for 2, 4, 6 hour by the powder pack-boronizing process using nano …

New results about the wear resistance of nickel boride layers under dry sliding conditions
were obtained in this work. For this purpose, an Inconel 718 superalloy was borided under …

High-temperature metallic materials operate in environments with a broad spectrum of
mechanical and chemical conditions, originating typical failures such as steam oxidation, hot …

Fracture toughness can be measured by microscratch test from objective force and depth
measurement, which is much convenient than indentation approach and conventional …

New results about the growth kinetics of nickel boride layers on an Inconel 718 superalloy
were obtained. The nickel boride layers were developed by means of the powder-pack …

Low wear resistance and high coefficient of friction of the Ti-6Al-4 V alloy surface limits its
application in situations requiring tribological participation of the alloy. In the present study, a …

Although the toughness and corrosion resistance of Ni-based superalloys are high due to
their face-centered-cubic structure, their surface hardness and, thus, wear resistance are not …

Rockwell C diamond indenter with a spherical tip of radius of 108 μm was used to slide on
bulk polycarbonate under linearly increasing normal load from 5 mN to 20 N in order to …

Boronizing processes were carried out at 900° C, 950° C and 1000° C for 2, 4 and 6 h to
improve the wear performance of Monel 400 alloy. According to microstructure analyses and …

As a classic film-resistant coating, DLC film is widely used in the field of impact wear. The
impact wear properties of DLC films with different thicknesses (1.1 μm thin DLC film and 7.9 …