Additive manufacturing–A review of hot deformation behavior and constitutive modeling of flow stress

R Motallebi, Z Savaedi, H Mirzadeh - Current Opinion in Solid State and …, 2022 - Elsevier
Hot working, as an important group of post-processing routes for additive manufacturing
technology (3D printing), is used to reduce the solidification/processing defects and …

Friction stir additive manufacturing–An innovative tool to enhance mechanical and microstructural properties

AK Srivastava, N Kumar, AR Dixit - Materials Science and Engineering: B, 2021 - Elsevier
Friction stir additive manufacturing (FSAM) method is one of the growing techniques of
additive manufacturing that utilizes the concept of solid state friction stir processing to …

Influence of friction stir processing on the friction, wear and corrosion mechanisms of solid-state additively manufactured 316L duplex stainless steel

AM Ralls, M Daroonparvar, AK Kasar, M Misra… - Tribology …, 2023 - Elsevier
Friction stir processing (FSP) was employed as a post-surface processing technique to
modify the tribological and corrosion behavior of cold-sprayed (CS) 316L SS deposits …

A review on manufacturing the surface composites by friction stir processing

S Bharti, ND Ghetiya, KM Patel - Materials and Manufacturing …, 2021 - Taylor & Francis
ABSTRACT Friction Stir Processing (FSP) has become a leading technique to produce
surface composite on the surface of various materials such as aluminum, magnesium …

Effects of friction stir welding tool tilt angle on properties of Al-Mg-Si alloy T-joint

HA Derazkola, N Kordani, HA Derazkola - CIRP Journal of Manufacturing …, 2021 - Elsevier
Friction stir welding tool tilt angle (TTA) is a vital parameter that influences the final joint
quality. The underlying mechanism of TTA in T configuration joints has not been fully …

Friction stir processing on the tribological, corrosion, and erosion properties of steel: a review

AM Ralls, AK Kasar, PL Menezes - Journal of Manufacturing and …, 2021 - mdpi.com
The eventual material degradation of steel components in bio-implant, marine, and high-
temperature applications is a critical issue that can have widespread negative ramifications …

A review of advances in cold spray additive manufacturing

RF Vaz, A Garfias, V Albaladejo, J Sanchez, IG Cano - Coatings, 2023 - mdpi.com
Cold Spray Additive Manufacturing (CSAM) produces freeform parts by accelerating powder
particles at supersonic speed which, impacting against a substrate material, trigger a …

A review on post processing techniques of additively manufactured metal parts for improving the material properties

KA Shiyas, R Ramanujam - Materials Today: Proceedings, 2021 - Elsevier
Metal additive manufacturing (AM) processes are used to produce metal parts with greater
design freedom and no material wastage from a CAD model, using powder or wire as …

Enhanced strength-plasticity of 2319 Al-Cu alloy formed by hybrid interlayer friction stir processing and wire-arc additive manufacturing

T Yuan, D Xu, X Jiang, P Zhao, S Chen - Journal of Materials Processing …, 2023 - Elsevier
Friction stir processing (FSP) technology can significantly improve the performance of
components prepared using wire-arc additive manufacturing (WAAM). In this study, a hybrid …

Friction stir butt-welding of roll cladded aluminum thin sheets: effect of microstructural and texture changes on mechanical properties

S Basak, M Mondal, K Gao, ST Hong… - Materials Science and …, 2022 - Elsevier
Experimental studies are carried out on the friction stir butt-welded aluminum (Al)-clad-
aluminum thin sheets. Aluminum alloy 4343 (AA4343, Al–Si series) and 3003 (AA3003, Al …