Deformation twinning is profusely activated in the Mg alloys due to lower critical resolved
shear stress (CRSS) compared to the non-basal slip systems (prismatic and pyramidal< c+ …

Abstract A new Mg-5.5 Gd-3Y-1Sm-0.5 Zr (1Sm) alloy was developed. The deformation
behavior and microstructure evolution of the Mg-Gd-Y-(Sm)-Zr alloys during hot …

In this study, the AZ31 Mg alloy sheets were fabricated by the traditional process of air
cooling after rolling and a new process of cryogenic treatment after rolling. The effect of …

The as-cast rare earth magnesium alloy is extremely difficult to be rolled due to poor
plasticity. In this paper, the rolled rare earth magnesium alloy thin sheet was successfully …

The strength–ductility trade-off dilemma is hard to be evaded in high-strength Mg alloys at
sub-zero temperatures, especially in the Mg alloys containing a high volume fraction of …

The rolled AZ31 Mg alloy sheets were manufactured by unidirectional rolling and cross-
rolling with two passes and five passes in this study. The improvement of multi cross-rolling …

This study explored the deformation behavior of rolled pure Mg and Mg-0.5 Ca alloy at room
temperature (RT) and cryogenic temperature (CT) of− 150° C. The samples were …

This study explored the influence of pre-stretching temperature on the microstructural
characteristics and deformation behavior of AZ61 magnesium alloy and its implications on …

In this study, ultrasonic surface rolling process (USRP) was used to fabricate a gradient
nanostructured commercial pure titanium. The site-specific microstructure, refining …

Magnesium alloys are the lightest structural alloys and have attracted substantial research
attention in the past two decades. However, their mechanical properties, including ductility …