In this study, the flow stress-strain curves of three typical titanium alloys, cast TA15 titanium
alloy (near α-type), cast Ti40 titanium alloy (full β-type) and cast TC21 titanium alloy (α+ β …

The effect of long-term isothermal aging of Haynes 230 super-alloy in an advanced ultra-
supercritical (A-USC) power plant at 700° C for up to 10,000 h on microstructural evolution …

The effects of recrystallization annealing on the microstructure evolution of Inconel 617B
alloy pipes and its tensile behavior at 750° C were investigated. As the annealing …

The high-temperature flow behavior, hot processing map, microstructure, and hot
deformation mechanism of Ti–6Al–4V–2Mo–2Fe (Ti6422) designed by the authors and …

IN740H, a Ni-based superalloy comprising a low-volume fraction of γ′, is a candidate
material to be used over long periods at high temperatures and stresses, as conditions …

Tungsten heavy alloys (WHAs) are typically refractory alloy, and machining tungsten alloy
components at room temperature is a challenge. Currently, Laser additive manufacturing …

The welding heat-affected zone (HAZ) of C-HRA-2 nickel-based alloy at different welding
peak temperatures (T p)(850 to 1450 C) was obtained through welding thermal simulation …

Strain-induced precipitation was systematically investigated in austenitic Inconel 617B
superalloy (IN617B) after deformation of 0.2 true strain in its service temperature range (700 …

A systematically investigation was conducted on the serrations of grain boundaries in
Inconel 617B alloy under a slow cooling. The objective evaluation of the degree of grain …

In this study, the GH4169 samples were prepared by Laser Melting Deposition (LMD) using
a SMAT 5M-060 HC fiber laser. By studying the effect of different powder feeding rates on …