Sulfur content of diesel fuel has been cut down to ultra low levels by environmental
regulation in many countries with the aim of reducing diesel engine's harmful emissions and …

Green diesel or straight chain hydrocarbons are produced by the hydrodeoxygenation of bio-
based feedstocks such as vegetable oils and bio-oils. Usage of green diesel for commercial …

Alumina-carbon nanotubes (AlCNTs) were prepared as a support and loaded with MoNi
catalyst (AlCNTMoNi). The same catalyst without the carbon nanotubes (CNTs) was also …

The selective removal of nitrogen-containing compounds from oil and oil fractions is of
interest because of the potential deleterious impact of such compounds on products and …

The algal biofuel technology has been accelerated greatly during the last decade.
Microalgae can be processed into a broad spectrum of biofuel precursors, which mainly …

A high level of hydrodenitrogenation (HDN) is required to achieve a desirable conversion of
other hydroprocessing reactions. This results from a strong adsorption of nitrogen …

Screening of modified ZSM-5 catalysts for conversion of glycerol to light olefins has been
investigated. In this study HZSM-5, Al/ZSM-5, Ca/ZSM-5, Cr/ZSM-5, Cu/ZSM-5, Li/ZSM-5 …

Abstract Three Mo promoted Ni-Al 2 O 3 co-precipitation catalysts with practically the same
composition (49–52% wtNi, 6-7% wtMo) were prepared using three different co-precipitation …

In the process of hydrodesulfurization (HDS) the activation of the dibenzothiophene (DBT)
occurs on the catalysts' active sites, in addition to the promoter. The distribution of both …

Aluminas with different boron loadings were prepared by impregnation with H3BO3
solutions and then used to prepare pure Mo and CoMo catalysts. According to infrared (IR) …