In this study, the feasibility of TIG welding of as-cast Mg–8Li–3Al–2Zn-0.5 Y alloys was
investigated, and the quality of welded joints using different welding currents was evaluated …

The microstructure and mechanical properties of a material are influenced by their
fabrication method. This paper addresses how the fabrication process influences the …

This study investigates the combined effects of microstructural modification by adding Ti, B,
Ni, and Cr alloying elements and heat treatment, homogenization and solid solution (T6), on …

Abstract A high-Zn Al–27Zn-1.5 Mg-1.2 Cu-0.08 Zr alloy was prepared by traditional casting
and melt spinning. The as-casted alloy consists of well-developed α-Al dendrites with many …

The processing route has an influence on the damping capacity, and in this study, the
influence of silicon carbide particle (SiCp) size on the damping capacity of AA6061 …

Commercial pure cast magnesium (Mg) was subjected to friction stir processing (FSP) at a
rotational speed of 600 rpm and tool traverse speed of 60 mm/min. The samples extracted …

One of the most perspective methods of hardening is friction stir processing. The study
shows processing methods based on the friction stir principle. The results of hardening of …

The present study investigates the friction stir processing (FSP) effect on the mechanical and
dynamic response of AA5052-H32. FSP was applied on a 1.5 mm thick aluminium sheet at …

A 100% overlap double pass friction stir process technique was developed for the
fabrication of AA1100/17-4 PH stainless steel composites, using an H13 tool steel cylindrical …

Одним из наиболее перспективных методов упрочнения материалов является
обработка трением с перемешиванием. В исследовании показаны процессы …