Cu-6% Fe (mass fraction) microcomposites containing (0–0.30)% rare earth elements were
prepared by cold drawing and intermediate heat treatments. Microstructure was observed …

Cu alloys with high strength, high electrical conductivity (EC) and good softening resistance
(SR) are urgently needed in many fields. A Cu-1.06 wt% Fe-0.44 wt% Ti alloy was designed …

In this study, high-performance Cu–0.69 Cr–0.46 Co–0.34 Ti (wt%) alloys with nano-
precipitates and nanotwins are prepared via a two-step cryorolling and aging process. The …

Abstract A novel Cu-Co-Ti alloy with high strength of 480 MPa, high conductivity of 81%
IACS and excellent softening temperature up to 600° C was fabricated via solid solution …

Abstract Cu-1Cr-0.1 Zr and Cu-1Cr-0.1 Zr-0.07 La alloy sheets were prepared by the
following process: vacuum casting–homogenization treatment–hot forging–solid solution …

A nanocompound-induced anti-softening mechanism is proposed for preparing high
strength and high conductivity CuCr alloys with favorable softening resistance. The …

A Cu-5 wt% Mo alloy with high conductivity and high anti-soften temperature were fabricated
by combining mechanical alloying with spark plasma sintering (SPS). Cu-5 wt% Mo mixed …

The low cycle fatigue behavior (Δε t/2= 0.4–1.0%) of a Cu-Cr-Zr alloy strengthened with
nanoscale precipitates has been tested at room temperature. The results showed that cyclic …

Microstructure evolution and properties of a Cu–Cr–Ag alloy during the continuous
manufacturing process were investigated in detail by scanning electron microscopy (SEM) …

Abstract Cu-0.45 Cr-0.2 Zr-xLa (x= 0–0.48) alloys were prepared by vacuum casting. The
effects of La addition and orientation on the microstructure and properties of the as-cast alloy …