In this work, the Taguchi technique was used to analyze the wear characteristics of
produced basalt fibre reinforced composites. The produced samples were tested for wear in …

Extraction of plant polysaccharides often results in a large amount of proteins, which is hard
to eliminate from the crude extract, and conventional approaches for deproteinization are …

Energy losses due to friction and wear in reciprocating machines could be potentially
reduced by applying new surface, materials and lubrication technologies for friction …

The exhaust manifold is a crucial component of the exhaust system in any SI engine,
responsible for efficiently expelling combustion products. However, when the exhaust …

Metal‐matrix aluminium composites are satisfactory successor not only for steels, but also
for aluminium‐alloys in several automotive units and components. There are various paths …

When friction processes occur, wear is generated. The generation of wear also leads to
airborne noise. There have been many research studies on wear and its correlation with …

Design Optimization of Exhaust Manifold’s Bending Radius for Spark Ignition (SI) Engine
through CFD Analysis on Low End RPM Us Page 1 Design Optimization of Exhaust Manifold’s …

This study emphasizes the fabrication of AA6061 reinforced with TiO 2 as a composite
addition to modify its mechanical and microstructural properties. This study adopted mold …

The surface wear in mechanical contacts under running conditions is always a challenge to
quantify. However, the inevitable relationship between the airborne noise and the surface …

There is a growing attention among researchers to the production of new composites with
low-density and low-cost processes. Aluminum based metal-matrix composites (AMMC) …