Three factors govern adiabatic shear localization: strain hardening (or softening), strain-rate
hardening, and thermal softening. It is typically associated with large shear strains (> 1), high …

Abstract Al–Zn–Mg–Cu alloys can be fabricated by a series of thermo-mechanical
processing methods (eg, hot rolling, forging and extrusion), which is able to serve in …

The effect of multi-pass friction stir processing and initial base metal condition on the
dynamic impact response of AA6061-T6 alloy at high strain rates was investigated in this …

The microstructures and mechanical properties of a Cu–Zn alloy subjected to dynamic
plastic deformation (DPD) at liquid nitrogen temperature (77K) were investigated. The planar …

The ballistic performances and deformation behaviors of AA5052-H112, AA5083-H112,
AA6061-T6, and AA7075-T651 aluminum alloy plates struck by 7.62 mm armor piercing …

This study details an investigation about the formation and development of adiabatic
shearing bands (ASB) in 7003-T4 aluminum alloy under high strain rate impacting. The …

Abstract A DMLS-AlSi10Mg_200C was subjected to dynamic loading at two strain rates. At
1680 s− 1, an ultrafine substructure formed inside the α-Al dendrites due to dynamic …

A considerable amount of adiabatic shear bands (ASBs) were obtained by means of the
thick-walled cylinder (TWC) external explosive collapse technique. Two types of shear …

When serving as a lightweight structural member in many areas, the dynamic mechanical
behavior of fiber-reinforced polymeric matrix composites, especially under different strain …

This paper investigated the compression behaviour of Al 6061-T6 alloys at various high
strain rates through split Hopkinson pressure bar (SHPB) experiments. The compressive …