This article describes joint use of two improving spectral efficiency algorithms for multi-
frequency signals: SEFDM (Spectrally Efficient Frequency Division Multiplexing) technology …

The signals used in telecommunication systems have a high peak-to-average power ratio.
To increase the efficiency of power amplifiers of such signals, an envelope tracking method …

When amplifying signals with a high peak-to-average power ratio, the envelope tracking
method is widely used to increase the efficiency of power amplifiers. When designing a …

A new FPGA architecture of the DVB-S2/S2X LDPC FEC encoder with low number of
resources consumption is proposed. The encoder is full rate compatible and supports all …

Amplification of signals with a high peak-to-average power ratio is accompanied by
decreasing of the radio transmitter's efficiency, which can be increased with the help of the …

The paper covers the problem of reducing distortion of switch mode power amplifier (SMPA)
output voltage using a neural network. Signal distortion in SMPA is mainly caused by …

In this paper, the optimal mathematical generic function model is established using the
minimum out‐of‐band energy radiation criterion. Firstly, the energy limit conditions …

This article describes a research of receiver which is part of SDR-modem based on SEFDM-
signals (Spectrally Efficient Frequency Division Multiplexing) with optimal envelopes. Three …

Software Defined Radio is the device used for radio communication in which software is
used to alter its various parameters like frequency selection, Modulation and demodulation …

This paper considers the improvement of DVB-S2 system by using bandwidth-efficient
multicomponent signals (MCS) with optimal shaping pulses. Finite optimal pulses are …