Digital image and volume correlation (DIC and DVC) are increasingly being used to
measure the deformation and damage behaviour of composite materials. The …

Digital image correlation (DIC) is an optical technique used to measure surface
displacements and strains in materials and structures. This technique has demonstrated …

Deformation measurement and control is a critical challenge in metal additive
manufacturing. The metal deposition and solidification occur under the condition of high …

Abstract Digital Image Correlation (DIC) has emerged as a pivotal non-contact, full-field
deformation measurement method over the past four decades, witnessing a remarkable …

This paper presents an in situ monitoring method for numerical controlled manufacturing of
large conceptual prototype based on multi-view stitching fusion (MSF). With the extensive …

Purpose The purpose of this study is to develop a deep learning framework for additive
manufacturing (AM), that can detect different defect types without being trained on specific …

The composite bolted joints are the weak points of overall structure, lacking an effective and
accurate monitoring method. In this paper, a novel MXene/CNTs film sensor with high …

In this study, a novel non-contacting electromagnetic cold expansion process (SEMCE) was
developed to improve the fatigue life of hole component. The deformation mechanism and …

In order to study the seismic performance of wall-beam out-of-plane joints with ECC post-
cast area, seven specimens and one comparison specimen were designed considering the …

The kinetics of macroscopic strain localization in a bimetal formed by electron-beam
cladding of a 09G2S low-carbon steel wire on a St. 3 substrate is studied. The mechanical …