A review on 1D photonic crystal based reflective optical limiters

R Gadhwal, P Kaushik, A Devi - Critical Reviews in Solid State and …, 2023 - Taylor & Francis
All-optical limiting devices are based on materials enabling light to control light, possessing
a nonlinear optical response, and are reviving their popularity. One-dimensional photonic …

Design and sensitivity improvement of microstructured-core photonic crystal fiber based sensor for methane and hydrogen fluoride detection

GP Mishra, D Kumar, VS Chaudhary… - IEEE Sensors …, 2021 - ieeexplore.ieee.org
This paper describes a gas detection sensor that is based on a microstructured-core
photonic crystal fiber (PCF). The finite element method (FEM) is used to analyze the …

Biophotonic sensor for the detection of creatinine concentration in blood serum based on 1D photonic crystal

AH Aly, D Mohamed, MA Mohaseb… - RSC …, 2020 - pubs.rsc.org
A new biophotonic sensor based on photonic crystal (PC) has been designed for the
detection of creatinine concentration in blood, and is considered an important small …

Graphene-based 1D defective photonic crystal biosensor for real-time detection of cancer cells

A Panda, PD Pukhrambam, F Wu, W Belhadj - The European Physical …, 2021 - Springer
Miniaturized biosensor with fabrication feasibility is of tremendous interest for point-of-care
testing of cancer cells. With this objective, we propose a novel biophotonic sensor based on …

A theoretical proposal for a refractive index and angle sensor based on one-dimensional photonic crystals

BF Wan, ZW Zhou, Y Xu, HF Zhang - IEEE Sensors Journal, 2020 - ieeexplore.ieee.org
In this article, a structure based on one-dimensional photonic crystals that can be used for
both angle sensing and refractive index sensing is proposed, which is achieved by optical …

Optimized bio-photonic sensor using 1D-photonic crystals as a blood hemoglobin sensor

SES Abd El-Ghany, WM Nouman, ZS Matar… - Physica …, 2020 - iopscience.iop.org
In this paper, a blood hemoglobin sensor is designed and analyzed by using a defected one-
dimensional photonic crystal (1DPhCs). A structure of a binary defected 1D-PC is proposed …

Theoretical study of a tunable low-temperature photonic crystal sensor using dielectric-superconductor nanocomposite layers

ZA Zaky, AH Aly - Journal of Superconductivity and Novel Magnetism, 2020 - Springer
One-dimensional hybrid photonic crystal made of a superconductor (YBa 2 Cu 3 O 7)
nanocomposite and dielectric material (silicon) is theoretically investigated by the two-fluid …

An ultra-fast all-optical 2-to-1 digital multiplexer based on photonic crystal ring resonators

MJ Maleki, M Soroosh - Optical and Quantum Electronics, 2022 - Springer
In this paper, a two-dimensional photonic crystal has been proposed for digital multiplexing
operation. The proposed structure includes chalcogenide rods with a linear refractive index …

Further optimization of the properties of Pr0. 6Sr0. 4Fe0. 9W0. 1O3-δ by Cu-doping as symmetric electrodes for solid oxide fuel cells

S Wang, Y Wu, H Chen, Y Gao, J Liu, M Li, Z Lü… - Journal of Alloys and …, 2023 - Elsevier
Abstract Copper-doped Pr 0.6 Sr 0.4 Fe 0.8 Cu 0.1 W 0.1 O 3-δ (PSFCuW) as a symmetric
electrode material is investigated for La 0.8 Sr 0.2 Ga 0.8 Mg 0.2 O 3-δ (LSGM)-based …

Analysis of a gas sensor based on one-dimensional photonic crystal structure with a designed defect cavity

N Kumar, B Suthar, C Nayak, A Bhargava - Physica Scripta, 2023 - iopscience.iop.org
A symmetric one-dimensional photonic crystal configuration with defect layer is proposed for
an optical gas sensor based device application. Here, Silicon and Si 3 N 4 are considered …