Abstract Al–Mg–Si alloy was subjected to multidirectional forging (MDF) at liquid nitrogen
temperature (LNT), to cumulative strains of 1.8, 3.6 and 5.4. The deformed microstructures …

The effect of microstructure on corrosion behaviour of an ultrafine grained (UFG) Al–4Zn–
2Mg alloy produced by cryorolling was investigated. Both UFG and coarse grained (CG) …

In this research work, Al/5Zn/1Mg (wt.%) composite sheets were produced by the
accumulative roll bonding (ARB) process and then converted into Al-5Zn-1 Mg (wt.%) alloy …

Abstract Effect of annealing and solution treatment prior to cryorolling on the formation of
initial structure influencing microstructure formation from nano to micron scale and resultant …

The effect of cryorolling on microstructural evolution and aging characteristics of an Al–4Zn–
2Mg alloy is investigated using differential scanning calorimetry (DSC), transmission …

Cryorolling is a severe plastic deformation (SPD) process used to obtain ultrafine-grained
aluminum alloy sheets along with higher strength and hardness than in conventional cold …

In this paper, an attempt has been made to enhance formability of cryorolled AA5083 alloy
sheets (annealed at 275° C for 15 min) in deep drawing of flat bottom square cup-shaped …

In this work influence of cryogenic forming on mechanical and fatigue properties are
investigated for Al-Mg (AA 5754) alloy. The received alloy is subjected to rolling at liquid …

The objectives of this study were to produce ultrafine-grained (UFG) AA2024 aluminum alloy
by cryorolling followed by aging and to evaluate its corrosion behavior. Solutionized …

Fabrication of microparts with large aspect-ratio and complex shapes remains a huge
challenge for industries and microforming is a potential solution to manufacture such …