The aim of the current paper is to review the available literature reporting on comparative
studies of heat-cured resins and three-dimensionally printed biomaterials for denture bases …

The proper selection of polymerization cycle is important to prevent overheating of the
monomer that could cause degradation, porosity and, consequently, deleterious effects on …

Nowadays, most products for dental restoration are produced from acrylic resins based on
heat‐cured Poly (Methyl MethAcrylate)(PMMA). The addition of metal nanoparticles to …

Purpose The aim of this study was to evaluate the bond strength between two types of
artificial teeth with a 3D‐printed denture base resin using different bonding agents. Materials …

Control of cross-contamination between dental offices and prosthetic laboratories is of
utmost importance to maintain the health of patients and dental office staff. The purpose of …

Purpose The objectives of this study were to investigate the flexural strength (FS) and
chemical interaction between 2‐tert‐butylaminoethyl methacrylate (TBAEMA) and a denture …

Rehabilitation of masticatory function in patients with absent teeth with removable dentures
is an established form of treating partial or complete dentition in edentulous patients. The …

Purpose: The purpose of this study was to evaluate, in vitro, the contamination of
toothbrushes and pacifiers by Streptococcus mutans, and the efficacy of microwave and …

Implant heating has been advocated as a means to alter the porosity of the bone
cement/implant interface; however, little is known about the influence on cement properties …

Purpose: The study aimed to compare the effect of different materials, thicknesses, and
polymerization methods and cycles, on the surface porosity of acrylic denture base resins …