Pineapple leaf fibers (PALF), as the part of a large productive system, based on the
availability of fruits for the food industry, offer a large amount of possibilities in term of use of …

The small size and thin part characteristics of the honeycomb floor panel for the aircraft part
product may cause problems in injection molding fabrication process. The objectives of this …

Dry fiber tapes have become an alternative to pre-impregnated tapes for automated fiber
placement. However, their industrial adoption is inhibited by high upfront research and …

Crank arm is one of the important parts in a bicycle that is an expensive product due to the
high cost of material and production process. This research is aimed to investigate the …

Pineapple (Ananas comosus) leaf fibers (PALF), as a by-product of one of the largest
productive systems in the agro-industrial field, appear as very promising for use in …

Fluidization is characterized as an activity that transforms fine solids into a liquid-state via
contact with either a gas or a liquid. Currently, Swirling Fluidized Bed (SFB) is one of the …

The aim of this study was to design a tooling system for manufacturing automotive
components using a natural fiber polymer composite (NFPC) material. As a case study, an …

Improper mold design or processing parameter setting could make a bad impact on the
appearance of molded part. It becomes more challenging if the ratio of the part size …

Injection moulding process parameters such as moulding temperature, melt temperature,
injection pressure, and injection time have a direct impact on the quality and cost of polymer …

The banana plant is unproductive after it has produced fruits once in its lifetime and the trunk
commonly be disposed. Among the disposing methods used are by herbicide injection and …