The range of applications for additive manufacturing is expanding quickly, including mass
production of athletic footwear parts, dental ceramics and aerospace components as well as …

The density of a typical endothermic hydrocarbon fuel (RP-3) at sub-and supercritical
conditions is measured using a novel density measurement method which is based on mass …

In this work, we present the automatization of a densimetric system for pVT measurements of
compressed fluids, operating over the temperature range from 283.15 K to 398.15 K and …

New density data for diethyl adipate (DEA) over 12 isotherms [(293.15≤ T≤ 403.15) K] and
15 isobars [(0.1≤ p≤ 140) MPa] are reported. This paper presents also the calibration …

The choice of cation and anion in an ionic liquid (IL) as well as the design of ion side chains
determine the fundamental properties of ILs, which permits creating tailor-made lubricants …

Casalini and Roland [Phys. Rev. E 69, 062501 (2004); J. Non-Cryst. Solids 353, 3936
(2007)] and other authors have found that both the dielectric relaxation times and the …

In this work, a scaling concept based on relaxation theories of the liquid state was combined
with a relation previously proposed by the authors to provide a general framework …

The use of biodegradable lubricants based on vegetable oils is receiving increasing
attention, being an important area of research, in order to promote products with a reduced …

This paper reports density and viscosity data for mixtures containing carbon dioxide (CO2), a
refrigerant fluid, and a lubricant (pentaerythritol tetrapentanoate (PEC5), pentaerythritol …

Squalane is being recommended as a secondary reference material for viscometry at
moderate to high pressure and at moderate viscosity. As part of this work, a correlation has …