The interactions between dislocations (dislocations and deformation twins) and boundaries
(grain boundaries, twin boundaries and phase interfaces) during deformation at ambient …

It is inherent knowledge that rolling contact fatigue (RCF) failure of subsurface-initiated
spalls usually occur under optimum surface under heavy load. However, our previous work …

The existence of angular and hard AlN inclusions would seriously deteriorate the service life
of high-nitrogen stainless bearing steels (HNSBSs). In this work, the formation mechanism of …

In this work, the microstructure and fatigue properties of the 17Cr2Ni2MoVNb gear steel after
gas carburizing (GC) and low-pressure carburizing (LPC) were comparatively evaluated …

Rotating bending fatigue tests, together with microstructural characterization, have been
performed on the high nitrogen martensite bearing steel Cronidur30. The results show that …

The controls of cleanliness and inclusion characteristics are important issues for the
manufacturing of bearing steels. In this work, the method of Mg pretreatment and Ce addition …

This study aims to investigate the effect of rare earth (RE) elements on the microstructure
and mechanical properties of bainite/martensite (B/M) bearing steel. For this purpose, GCr15 …

A new double vacuum melting route (conventional second refining+ vacuum arc refining
[CSR+ VAR]) with 33% lower production cost than the traditional VIM+ VAR route has been …

This study aims to explore the very high cycle fatigue performance of GCr15 bearing steel
produced by two different melting routes by ultrasonic fatigue testing. The results show that …

Semi-macrosegregation in continuously cast blooms and its associated carbide banding
defects in hot-rolled bars were investigated to explore the characteristics, evolution, and …