Determinations of reduced stress tensors using fault slip data yield the orientation of
principal stress axes and the ratio Φ of the differences between principal stress magnitudes …

All normal-fault systems must terminate both along and orthogonal to strike. As many as four
terminations may be associated with a single culmination. Most normalfault systems …

Abstract The Basin and Range province at the latitude of Las Vegas, Nevada (approximately
36° N), is ideally suited for reconstructing Neogene extension owing to an abundance of …

Low-temperature deformation is characterized by heterogeneous strain in which the bulk of
the material clearly retains its primary texture. Deformation is by grain-scale crystal plasticity …

Abstract The Puna-Altiplano, a 500,000-km2 area at an average elevation of 3.7 km in the
central Andes, occurs in a non-collisional plate setting over a 30°-east–dipping segment of …

Low-temperature, basement-involved compressive folds are confined largely to the hanging
walls of thrust faults and appear to be produced in response to both propagation and slip on …

Well polished or reflective fault surfaces, with or without linear striae indicating the sliding
direction, are commonly referred to as slickensides. This study examines the development of …

STRUCTURAL ANALYSIS & SYNTHESIS STRUCTURAL ANALYSIS & SYNTHESIS A
LABORATORY COURSE IN STRUCTURAL GEOLOGY Structural Analysis and Synthesis is …

[cat] L'objectiu d'aquest treball és l'estudi de l'estructura i de l'evolució tectònica durant el
Terciari d'un sector del nordeste d'Ibèria que comprèn part de les tres unitats tectòniques …

This paper shows that the Hough transform, a basic technique of image processing, is useful
for separating stresses from heterogeneous fault-slip data. The present method enumerates …