Putting 3D printing to good use—Additive Manufacturing and the Sustainable Development Goals
J Muth, A Klunker, C Völlmecke - Frontiers in Sustainability, 2023 - frontiersin.org
Additive Manufacturing (AM), often referred to as 3D printing, is expected to have a high
impact on the manufacturing industry as well as on society. The inherent characteristics of …
impact on the manufacturing industry as well as on society. The inherent characteristics of …
Two-stage meta-heuristic for part-packing and build-scheduling problem in parallel additive manufacturing
SJ Lee, BS Kim - Applied Soft Computing, 2023 - Elsevier
This paper studies the part-packing and build-scheduling problem in parallel additive
manufacturing. The multi-part grouping, 2D placement, and 3D rotation should be …
manufacturing. The multi-part grouping, 2D placement, and 3D rotation should be …
A combined imaging, deformation and registration methodology for predicting respirator fitting
S Caggiari, B Keenan, DL Bader, MN Mavrogordato… - PloS one, 2022 - journals.plos.org
N95/FFP3 respirators have been critical to protect healthcare workers and their patients from
the transmission of COVID-19. However, these respirators are characterised by a limited …
the transmission of COVID-19. However, these respirators are characterised by a limited …
A video-based method for supporting automated facial mask customization
Mass customization is the concept of integrating advanced designing and fabrication
approaches to produce personalized products while ensuring efficiency and low cost over …
approaches to produce personalized products while ensuring efficiency and low cost over …
[HTML][HTML] An automated design pipeline for transparent facial orthoses: A clinical study
Statement of problem Transparent facial orthoses (TFOs) are commonly used for the
treatment of craniomaxillofacial trauma and burns to prevent hypertrophic and keloid …
treatment of craniomaxillofacial trauma and burns to prevent hypertrophic and keloid …
Two-Stage Meta-Heuristic for Part-Packing and Build-Scheduling Problem in Parallel Additive Manufacturing
SJ Lee, BS Kim - Available at SSRN 4113619, 2022 - papers.ssrn.com
This paper studies the part-packing and build-scheduling problem in parallel additive
manufacturing. The multi-part grouping, 2D placement, and 3D rotation should be …
manufacturing. The multi-part grouping, 2D placement, and 3D rotation should be …