[PDF][PDF] Platinum-containing carbon nanostructures for the creation of electrically conductive ceramics using 3D printing of CJP technology

OD Zolotarenko, EP Rudakova… - Fizika ta Tehnologia …, 2022 - jnas.nbuv.gov.ua
When studying the suitability of platinum-containing carbon nanostructures for 3D printing of
CJP (ceramic printing) technology, it was found that for the use of platinum-containing …

Атоми впровадження у кристалічній гексагональній структурі

ZA Matysina, AD Zolotarenko, OD Zolotarenko… - Хімія, фізика та …, 2023 - cpts.com.ua
Анотація В рамках роботи розглянуто гексагональну структуру металів типу В19 як
сорбентів водню. Розглядаються кристалічні ґгатки, де в міжвузлі металу …

Synthesis of nanotubes in the liquid phase

DV Schur, AG Dubovoy, EA Lysenko… - … Materials Science and …, 2005 - Springer
SYNTHESIS OF NANOTUBES IN THE LIQUID PHASE SCHUR DV DUBOVOY AG,
LYSENKO EA, GOLOVCHENKO TN, ZAGINAICHENKO S.Yu., SAVENK Page 1 …

Heat flux and temperature prediction on a volumetric receiver installed in a solar furnace

MI Roldán, R Monterreal - Applied energy, 2014 - Elsevier
This paper presents a prediction procedure of the solar irradiance distribution on a plane
parallel to the focal one of the Plataforma Solar de Almería's Solar Furnace, within defined …

Combining thermal and optical modeling to optimize the performance of a flat plate absorber at various locations in a solar air collector

HA Maarof, M Shamsi - Journal of Studies in Science and …, 2022 - engiscience.com
Increasing the absorber plate surface in a solar air heater system (SAHs) can increase
thermal efficiency, heat transfer coefficient, and Nusselt number. This paper includes the …

Mirrors array for a solar furnace: Optical analysis and simulation results

D Jafrancesco, P Sansoni, F Francini, G Contento… - Renewable energy, 2014 - Elsevier
The optical design of a concentration system for a solar furnace is studied, proposing
several possible solutions. The foreseen use of this solar furnace is to test components and …

Synthesis of carbon nanostructures using cheap grades of graphite

ОД Золотаренко, ОП Рудакова, НЕ Аханова… - Поверхня, 2022 - surfacezbir.com.ua
The method of electric arc evaporation of graphite in an inert gas environment is relatively
common, productive and quite effective, as allows to obtain both soluble [1–11] and …

Solar synthesis of nanostructured zirconia: microstructural and thermal characterization

LG Ceballos-Mendivil… - Materials Research …, 2020 - iopscience.iop.org
The use of concentrated solar energy in processing ceramic materials is an attractive route
to obtain these materials with low CO 2 emissions. In this work, nanostructures of monoclinic …

[PDF][PDF] Problem on fullerene production by electric arc method

NS Anikina, S DV, ZAD Simanovskiy АP… - … journal of hydrogen …, 2001 - ichms01.ichms.org
According to literature data the fullerene synthesis from graphite in the arc discharge is the
most successful method. However, mechanism of the fullerene formation from the graphite …

Influences of optical factors on the performance of the solar furnace

Z Cui, F Bai, Z Wang, F Wang - Energies, 2019 - mdpi.com
In this paper, an optical structure design for a solar furnace is described. Based on this
configuration, Monte Carlo ray tracing simulations are carried out to analyze the influences …