This paper presents an experimental investigation of wire electro-discharge machining
(WEDM) of titanium alloy. The objective is to investigate the effect of seven process …

This study proposes a new EDM method using longitudinal-torsional ultrasonic vibration
(LTV) electrodes for micro-hole machining to address the problems of debris removal and …

To improve the processing efficiency and precision of micro-holes with a large depth-to-
diameter ratio on titanium alloy, ultrasonic vibration-assisted micro-electrical discharge …

In this study, scanning electron microscopy (SEM), electron backscatter diffraction analysis
(EBSD), and electron probe microanalysis (EPMA) were used to investigate the impact of …

In traditional electrical discharge machining (EDM) of micro-holes, the debris removal
becomes increasingly challenging as hole depth increases, significantly affecting the …

The current investigation was, to optimize the parameters for wire cut electric discharge
machining (WCEDM) of Al7075 alloy based matrix composite. The Al7075 alloy …

This study presents a novel hybrid artificial neural network (ANN) meta-heuristic model to
predict and optimize titanium alloy (Grade 5) in wire electrical discharge machining (WEDM) …

The surface of steel substrate was pretreated by nickel plating and Aluminum/nickel-plated
steel bimetal was prepared by compound casting. After liquid aluminum was casted on the …

Titanium alloys are considered as' metals of future'because of their exceptional properties
such as high strength to weight ratio, high specific strength, corrosion resistance etc and …

Amongst the titanium alloys, Ti–6Al–4 V has high strength, higher corrosion resistance and
high creep resistance. Though, conventional machining process is not suitable for titanium …