In the present paper, three nickel base alloys (Inconel 718, Inconel 625 and Monel-400)
have been studied for chip formation in the hot turning process using flame heating. Cutting …

Hot machining is considered one of the new techniques in the machining of hardened steels
to improve their machinability and surface finish. These materials are difficult to be machined …

This paper presents a desirability function approach in order to find out an optimal
combination of Machining parameters for multi-response parameters in hot turning operation …

The flank wear and cutting power in the hot turning of Ni-Hard nickel based alloy by carbide
tool was investigated in terms of cutting parameters such as cutting speed, feed rate, depth …

Nickel base alloys are frequently used in aerospace industries, marine, biomedical
application and other demanding industries due to their high strength, high hardness …

In the present work DEA (data envelopment analysis) coupled with Taguchi method has
used for optimization in process parameters of hot turning operation. An experimental …

In this work, cutting force, feed force and surface roughness was studied under the influence
of machining parameters namely cutting speed (Vs), feed rate (fs) and depth of cut (ap) at …

Insurance of surface quality and dimensional tolerances in finish turning necessitates the
development of accurate predictive models. This study aimed at modeling flank wear of …

This paper envisages the optimization of machining parameters in hot machining using
Taguchi Method. Experiments were conducted on 15-5 PH stainless steel using coated …

International Journal of Advance Research in Engineering, Science & Technology Performance
Evaluation and Parametric Optimi Page 1 International Journal of Advance Research in …