Plant protection control based on the spray application of plant protection products is a very
complex task depending on a series of factors, among which droplet size is the most …

In this work, planar two-photon laser-induced fluorescence (2p-LIF) is applied for the first
time to analyze the fluid dependent spray structure and atomization behavior of water and …

We present a combined experimental-numerical study of the primary breakup of a single-
phase attenuating liquid sheet emerging from a flat fan nozzle. An experimental setup has …

An experimental study was performed to investigate the influence of injection angle on
further details of breakup of a circular liquid jet injected into an airstream. Wavelength and …

Argon gas injection into a continuous casting mold facilitates many factors related to smooth
and long casting sequences by reducing nozzle clogging, improvements in steel cleanliness …

The dynamic behavior and disintegration mechanisms of a fan liquid sheet in a quiescent
atmosphere are investigated over a broad range of differential injection pressures up to Δ …

The present study investigates the influence of preheating temperature on the internally
mixed twin-fluid atomization of a high-viscosity fluid, known as fast pyrolysis bio-oil (FPBO) …

As far as we are aware, all the previous studies have focused on circular injectors. Here, the
effect of non-circular orifice shape on pressure swirl injector was investigated …

We consider the effect of water spray configuration on the fineness and uniformity of a metal
powder produced by water atomization of a melt stream. The effects of water spray travel …

Gas injection into a slab continuous casting mold is a common practice as it enables long
casting sequences by reducing SEN clogging. However, too much gas injection can …