In this study, the CZTSSe (Cu 2 ZnSn (S, Se) 4) solar cells, with Al/ZnO: Al/ZnO
(i)/CdS/CZTSSe/Mo structure, have been simulated. The simulation results have been …

In this paper, a new CZTS/CZTSSe tandem solar cell design has been proposed to reach
ultrahigh efficiency values at low fabrication cost. The proposed tandem design consists of a …

This paper presents the use of AZTS, a non-toxic and earth abundant material as buffer layer
in CZTS solar cells due to its good lattice match. We have performed simulation on the …

An effective and optimised BSF layer is an important layer in both single junction and
multijunction solar cells. In this work the use of the double layer BSF for top cell with their …

In this research work, SCAPS-1D simulator is used to model and investigate the CZTS (Cu 2
ZnSnS 4) solar cells. A substrate cell structure ZnO/CdS/CZTS/Mo was used as a base …

In this study, solar cells based on pure Cs2AgBiBr6 and Al-doped metal were fabricated
using the sol–gel spin-coating technique. X-ray diffraction (XRD) analysis confirmed the …

For further efficiency improvement in kesterite-type Cu2ZnSn (S, Se) 4 (CZTSSe) solar cells,
it is essential to address the carrier recombination issue at the back electrode interface (BEI) …

Multijunction solar cells (SCs) have excellent potential to achieve higher efficiency for
increased sun concentration. The two‐step photon absorption in the quantum wells (QWs) …

This study utilized the 2-D Silvaco ATLAS simulator to design and optimize the CIGSe thin-
film solar cell (TFSC), considering experimental results from the hybrid-deposited CIGSe thin …

GaInP and GaAs being promising materials for large scale photovoltaic applications, the
effect of temperature on the electrical parameters of a GaInP/GaAs tandem solar cell has …