Technological advancements and the growing material set in the world have created a large
variety of options for industrial designers, but little attention has been given to the tools and …

Material selection problem can be interpreted as an intricate MCDM problem. The aim of this
work is to provide a simple and comprehensive MCDM-based framework for solving this …

This review article deals with orientation controlled growth of Carbon Nanotubes (CNTs).
Vertically aligned CNTs (VACNTs) are considered as the best type of CNTs among all …

Weight penalty has been a challenge for design engineers of aerospace vehicles. Today's
high-efficiency combat aircraft undergoes intense stress and strain during flying missions …

Purpose In most developing countries riveting, upset forging and punching operations
among others are performed using manual hammering technique. The use of the manual …

Purpose The purpose of this paper is to present a comprehensive review on development
and future trends in zinc oxide thin film transistors (ZnO TFTs). This paper presents the …

This article describes the material selection for microheater in micro-electromechanical
systems (MEMS)-based gas sensors. The analysis was done using multicriteria decision …

Bu çalışmanın amacı, otomotiv sektöründe faaliyet gösteren bir firmanın sahip olduğu
patentlerin değerlerine göre sıralanması olarak belirlenmiştir. Bu amaçla, öncelikle patent …

This paper presents the investigations on high-κ dielectrics for low operating voltage and
low leakage zinc oxide thin film transistor (ZnO TFT) using three material selection …

Performance parameters of an organic thin-film transistor (OTFT) and their relation to the
material parameters of the gate dielectric are analyzed. Based on the analysis, the surface …